Skip to main content

Engine moved to garage

Engine was assembled in-house (it was not without comments ..). My garage is to cold and to smal for any work on engine, specially during the winter . With only new engine parts assembling engine in-house was no problem regarding any dirt or oil. And it was warm and pleasant sitting in my sofa assembling - I can recommend it ;-) The only worry was how to move the engine out in the garage when due. Today I decided to move it. Couple of hours later and without any assistance - engine is ready for going into car.


I will install engine in car on Saturday. Hopefully it will go in as easy as it came out. 






Comments

Popular posts from this blog

ATI superdamper 917274 and serpentine belt system

I decided to get an ATI superdamper and it landed yesterday (order by Summit). The damper includes a crank hub and it is special version for LT1 gen II SBC (Corvette C4 92 - 96 model). I had to hone the crank hub to get it on. With the damper installed I could also install the serpentine belt system.
The diameter of the ATI superdamper is 7.530" and diameter of stock damper is just over 7". The stock serpentine belt is to short. As shown on the pictures the drive belt tensioner is not part of the system with stock serpentine belt. Stock belt is 67 or 68 in long. I have measured  inner length of new belt to be about 69 in. I probably need a new belt which is close to 70 in long. I will try a couple of belts and check the marks on belt tensioner to find the correct length. 
UPDATE 1 : finding a correct length serpentine belt with ribs on both sides is difficult. Stock length is OK to find but slightly longer is not easy. 92 models and early 93 models Corvette C4s used serpent…

What´s done?

This year it is engine and transmission which both are completely overhauled.  Next winter brakes and suspension will be overhauled. Picture is engine today (mid February 2012). An ATI superdamper 917274 will be also be installed before engine is going back into car. Last in this post there is a list of whats done.


The following is summarized whats done (engine) this year:
Engine 383 street/strip shortblock from Golen Engines (internally balanced). 16 cc dish Mahle forged pistons (16 cc dish together with 54 cc in top, zero decked is about 11:1 in compression)ARP main studs (4-bolt engine)SCAT Cast steel crank 3.75" strokeScat 4340 Forged I-Beam rods, 6" length, ARP rod boltsTrickFlow 430 HP GenX Top End Engine Kits for GM LT1Heads and cam1.6 roller rockersIgnition MSD Ignition 8381 MSD Ignition Pro Billet LT1 Distributors (optispark distributor)MSD Ignition 32129  MSD 8.5mm Super Conductor Spark Plug Wire SetsMSD Ignition 8226 MSD Blaster GM Coils a new tune from PCM4less (sp…

Engine and trans ready for car

"Moment of truth" is getting closer. Today engine and transmission were bolted together. The torque converter should not be "pressed" on the flexplate (will probably eat up thrust bearings if done). After gearbox and engine were bolted together the torque converter and flexplate were bolted. Before bolting flexplate and converter I had to slide the converter about 10 mm against flexplate. Important to use correct torque on both bellhouse and flexplate bolts. Engine going back into car after easter.




The flexplate (TCI flexplate for internal balanced engines) was bolted on crank. The engine was supported on the engine mounts and block.